Setup and Recording:

Guitar and bass: The guitar and bass were both recorded using an Axe FX pre-amp, running into Helix board 18 fire wire digital mixer set up with a recording track in logic. The tone/virtual amp setup for the guitar was an off axis miking of a virtual Recto Orange amp. The bass was run through the Axe FX and into the mixer as a direct signal.

Drums: The drums were programmed with MIDI using Superior Drummer software.

Synths: The synths were programmed with MIDI using the Nexus plugin.

Voice: All vocals were recorded in a small room with little treatment using an AKG Perception 220 running into a DI interface, into a recording track in logic. A pop filter was used and singer/vocalist stood a few inches away from pop filter with that a few inches from the mic.

Processing and Effects:

Guitar: The 2 guitar parts were panned hard left and hard right. Both being processed with CLA Guitar plugins from waves, to add a little reverb, compression and EQ colour, some frequencies were then EQed out separately. Intro riff was notch EQed for effect.

Bass: The bass was EQed with a high roll off and some mids cut out, then compressed lightly.

Synths: Synths were given some Drastic EQ dips, peaks and roll offs to help stop masking. Delay and reverb were applied in the plugin whilst creating the sound.

Drums: In the plugin: Kick and snare were EQed and compressed. The toms were noise gated and compressed, some were also filtered. All drums except overheads and hats were bussed to a separate channel and given parallel compression. This bus was then sent to the main out with everything else at a lower level to add an intense thickness to the sound. Drums were all panned to the appropriate places to where a drummer would be sitting. Out of the plugin (aka the drums as a group:) Multipression to compress upper mids was applied, as well as a limiter at a low threshold to keep from peaking.

Vocals: All sung vocals were given a tight reverb, relatively strong compression, some stereo widening (particularly on the harmonies) and some EQ for colouring. Often harmonies were pushed down in volume to keep them from masking the main melody. Screamed vocals were triple tracked, EQed, had reverb applied, and compressed slightly. One track was panned half left, one half right, and one widened to maximum.

Checked phase correlation using a correlation meter plugin and frequency spectrum using a multimeter plugin.

Mastering: Mastering was done using iZotope Ozone 4. In the paragraphic equalizer some lower mids were cut, as well as some of the highs, as there was a lot of hiss. A limiter was added with a -4.2dB threshold to really improve the loudness of the track. A harmonic exciter was added to enhance the higher frequencies in particular. A multipressor was used to compress all the frequencies with slightly different amounts, as the mix needed it to help translate to other speakers in my house, crossovers were set at 80Hz, 324Hz and 5.05kHz. A multiband stereo imager was used to centre all frequencies below 80Hz a little and widen all frequencies above 5.05kHz quite a lot.

IZotope Ozone 4 also has a built in correlation meter, level meters and phase monitoring allowing keeping tabs on phase cancelation and peaking. Mix was converted  to mono to listen, however, just to be sure.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s